Astaria

Are you trying to Fix PS3 Yellow Light of Death? In fact, this problem occurs because of the low grade thermal paste or heat sync paste used on these processors. To combat this problem first follow these simple steps to analyse the extent of damage to your PS3 .If you are lucky and the level of damage is less than your system can be revived.A. If you feel your PS3 has been caught by heat, then switch it off, wait for 20minutes and switch it on again.B. Check for any loose cables.C. Take out the hard drive of the PS3 and put it back again. Repeat this procedure two to three times for better results.If these steps do not work to fix PS3 yellow light of death then either you can send it to the respective company which is undoubtedly a very expensive option or you can download a stepwise audio video guitar strap locks guide. This is the best and most recommended way and it was found that users who had no knowledge of hardware were able to fix their consoles in one hour with the use of the repair guide. Keep the following points in mind while getting on with this job.Procedures to Fix PS3 Yellow Light of Death#1 You will require a heatgun, 3 screw drivers-1 torex, 2 robinsons (small and large), 1 phillips, high grade thermal paste and some isopropyl alcohol.#2 This shouldn’t be a problem if you have worked on PC’s before.#3 Download ?The Gilksy Guide’ and go through it several times so as to be clear about every step.#4 Note the manner in which the PS3 is sitting at every step.#5 Preferably take a print out of the guide and keep it open on your PC.#6 The complete procedure should be completed in one sitting i.e.